Diode Dynamics DIY Tail-as-Turn Modules — Pair
Combine the existing LED tail-lamp and turn-signal functions with a wired DIY module. This version is for an installer who can identify the correct circuits and verify the electrical load.
Check your vehicle and original lighting
- Requires factory LED tail lights and a separate original incandescent turn-signal circuit. This is not a vehicle-specific plug-in harness.
- Experienced automotive wiring knowledge is required. The module is limited to 1 amp and is not for powering incandescent tail lamps.
- A suitable resistor or flasher may be required to prevent hyperblinking.
What is included?
- Two Tail-as-Turn modules with butt-terminal connectors.
Installation and warranty
Identify the required circuits and follow the exact wiring instructions. This is a wired installation, not a universal plug-in adapter. Test the affected lighting functions after installation. The product carries a 3-year limited manufacturer warranty.
Manufacturer fitment and installation information
Questions before ordering
Does this replace the light housings?
No. This package supplies the modules and only the supporting parts listed above. The vehicle’s original lamp housings remain in use.
Is this a plug-in, vehicle-specific harness?
No. This is a wired DIY module pair for factory LED tail lamps and a separate original incandescent turn-signal circuit. The installer must identify the circuits and keep the LED load within the 1-amp limit.
Browse Automotive Accessories.
