Stage Series · SS10 Chase
One compact bar. Three rear-facing functions.
White reverse light, a Red brake section and programmable Yellow chase patterns in one universal bar.
Choose the mount for your build
DD8931 is a universal auxiliary light, not a Tacoma-specific bolt-on kit. Choose a rear-facing rack, bumper or other suitable mount with room for the brackets and cable routing. The included adjustable brackets fit a suitable mounting surface; dedicated roll-bar mounts are separate.

Keep each light function distinct
| Function | Output and control |
|---|---|
| Reverse / work light | White output from the Blue input, activated by a verified reverse signal or suitable independent control. |
| Brake | Dedicated Red section with solid, triple-flash SafetyStrobe or slow off-road pulse. |
| Chase | Yellow output with 20 selectable patterns, independently controlled from the Yellow input. |
Chase takes priority over the White reverse function. The Red brake section is separate. Choose a pattern and operating mode appropriate to where the vehicle is being used; the slower brake pulse is intended for off-road use.


DD8931 package
- One SS10 LED Chase Light.
- Magnet tool for SmartTap programming.
- 3-metre DT extension and wiring pigtail.
- Mounting brackets, hardware and two zip ties.
Extra wiring or extensions may be needed for your mount and signal sources. A vehicle-specific harness, switch panel and dedicated roll-bar mounts are not included.

Wire by function, then choose the pattern
Use verified brake, reverse/work and switched chase circuits. Vehicle wire colours and connector positions vary. SmartTap changes the powered function’s pattern with each pass of the magnet; the chosen pattern is retained after power is removed.
Built for an exposed installation
The SS10 Chase has an IP69K intrusion rating.
Covered Stage Series lights have a limited lifetime manufacturer warranty. Commercial, industrial and fleet use is limited to eight years; wiring and other bundled accessories have their own terms. Read the manufacturer warranty.
Is this a Tacoma plug-and-play kit?
No. This is the universal DD8931 light with brackets and a pigtail. The installer must choose a suitable mounting location and verify the signal connections.
Can the reverse light stay on with chase active?
The Chase function takes priority over Reverse. The Red brake section is separate.
How do I select a pattern?
Power the function being configured and pass the supplied magnet over the sensor shown in the guide. Each pass advances one pattern; observe the light itself because there is no separate programming indicator.
Plan your 4Runner lighting
Compare this part with other supported applications and confirm original equipment before ordering.
Shop 2014–2024 4Runner lighting · Read the 4Runner buying guide






















